Ask Experts Questions for FREE Help !
Ask
    NorPlan's Avatar
    NorPlan Posts: 425, Reputation: 3
    Full Member
    		  
    #1

    May 19, 2014, 08:00 AM
    Quick Connectors / Backyard Pool...
    We decided to go with the Quick Connectors on the Backyard Pool... I'm using the grooved ended ones where the hose fits on... Out of 5 installed 1 just has to leak I tried moving the clamp to tighten over the grooved area, still dripping... Just happens to be the Hose from the Pump to the Filter @ the Pump end.. Surprisingly with the pump turned off and all connections wiped down, No Leaking.. Any Ideas? Would an additional clamp do the trick? Cheers, Thanks...
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    May 19, 2014, 09:30 AM
    Hi Norplan

    So you are using HOSE BARB type fittings like in the picture below, yes (yours may be plastic)? If you are using hose fittings and the typical plastic pipe associated with these fittings then you actually want to HEAT the plastic tube just a little and then tighten the clamp onto the hose/fitting joint. In many cases, I use two clamps at each joint but that is because I can't have any call backs or the job is a loser for me, right?

    Anyway, heat the hose a bit and use two clamps and you should be all set here!

    Mark
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Sharkbite connectors [ 5 Answers ]

Thanks to "MASSPLUMBER"'s excellent advise I have successfully removed our old jacuzzi and also old shower stall. Now am going to repair holes in flooring which I had to cut to facilitate accessing drains and water supply pipes for old above units.Then install new sub floor over original...

Wago connectors [ 4 Answers ]

Any thoughts out there on these push on type connectors?

PS/2 connectors [ 1 Answers ]

Hi Again! Matt here, I've just installed a new motherboard in my computer everything works great except that I can't use my keyboard or my mouse unless I use the USB ports. I would rather use the PS/2s but can't figure out why they won't work. I tried looking for and adding drivers to no avail....

Romex connectors [ 1 Answers ]

Going into the main breaker panel, can you put 2 romex wires through one romex connector (3/8") Also if allowed, can you run (1) 6/3 and (1) 8/3 romex wire through a 1" romex connector? Thanks all.

Crimp connectors [ 1 Answers ]

What’s the proper way to install crimp connectors? Not butt splice connectors, I have used those many times. These connectors (made by GardnerBender) are plain metal and look like short pieces of tube. The instructions are confusing: insert wires, twist together then crimp. Are both wires...

View more questions Search