Ask Experts Questions for FREE Help !
Ask
    NicoleLacy's Avatar
    NicoleLacy Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 1, 2010, 08:51 AM
    Why is there so much water on bathroom floor despite turning valve off behind toilet?
    I noticed that water was dripping out from the handle of the toilet in a bathroom in my house. I turned off the valve below the toilet and noticed that the ball in the tank was not floating properly because it had a hole in it near the base where it connects to the rod. This obviously caused the rod and ball to float high enough to stop the water from rising above maximum after the toilet was flushed. This resulted in the water dribbling out from the handle. I realize that I will need to replace the ball and rod contraption ( not sure what it is called). Even though I shut the valve off, I noticed that sometime, overnight, water still leaked from the handle. I would normally assume this was because I forgot to flush it or drain it a bit below the handle. Now the carpeted floor is soaked, and even some water dripped on the first floor from the ceiling below the bathroom. My real question is how come there was so much water even after I turned the valve off? I don't think that even after 9 hours, there should be that much water collected from a dripping toilet handle. By the way, the tank was still fairly full in the morning. Should I be worried that something else is leaking? By turning the valve off did I create some unknown back pressure?
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
     
    #2

    Dec 1, 2010, 09:30 AM

    The angle valve may be defective and is not shutting off water.

    Shut water off at main .Open a faucet at the lowest point in house. This will drain water from rest of house.

    Remove handle on valve. Remove packing nut that is located behind handle. Remove spindle and replace washer.

    This should correct problem with valve.

    Drain toilet tank and sponge remaining water so it is dry inside tank. On bottom of tank, remove feed line from tank.

    Remove bolt holding ballcock and remove ballcock from tank.
    Replace with a flowmaster filler.See picture on left. Follow directions on box for install and operation.

    Chuck.
    Attached Images
     
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #3

    Dec 1, 2010, 11:18 AM

    You have an additional problem. See the overflow pipe above the flapper, it should be lower than the handle hole in your tank. Water should never be able to rise as high as the handle, they are never water tight.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Toilet water shut off valve won't tighten. And I flooding bathroom [ 1 Answers ]

My toilet will not stop running, and fills up the bowl and floods. I tried to shut off the water, however the valve keeps spinning and will not tighten.. Please help.. My bathroom is flooding

Toilet valve not turning off water to toilet [ 1 Answers ]

Toilet valve will not turn off water to toilet... keeps running

No cold water after turning valve back on [ 2 Answers ]

We just installed a new kitchen sink and faucet. The water has been off for about 2 weeks while we worked on the floor and cabinets. Today we turned the water back on, and there is no water coming out of the cold line below the sink. The valve seems to be opening fine, and the second shut off...

No Shut Off Valve between water heater and bathroom sink valve [ 14 Answers ]

I have a constant drip in my bathroom sink. After a little trouble shooting, I came to the conclusion that my hot water valve underneath the sink is the culprit. I traced the pipe down the wall, into the basement and to the water heater. The only thing between the water heater and the old valve in...


View more questions Search