 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Why does the pressure switch on my well keep going out
I continually have to change pressure switches every few months. It works fine for a while and then I'll notice it will stop working and I can smack the top of the switch and it will go back to work again for a few days but then eventually smacking it stops working and I have to replace it only to start all over again. This ia very annoying since I have two water source heat pumps that I have to reset every time the water goes off. HELP! [email protected] I have included email since I mightt not find this site again.
|
||||
Check out some similar questions!
Model #9013FSG2J21BP
I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals
I lost water in my home overnight. The pressure gage reads about 8 PSI. If I use the lever on the pressure switch to close the contacts, nothing happens. Actually, the pump controller box, makes a buzzing sound for a couple of seconds, but that's it. Does anyone have any thoughts? I don't...
The only way I have water pressure is to leave the power on! I have replaced the 5 gallon pressure tank (28psi when void of water)/fittings/pressure gauge and tried 3 new 30/50 pressure switches and the problem remains the same. With the power off, the pressure drops to 0 (not 30). When I...
Hi, I've got a goodman furnace (mod. # GHT070-3) it's about 5 years old. Recently, the heat will only kick on for about 30 seconds then shut off. It's giving me 4 flashes: Open limit switch, then it kicks off. After that it gives me 3 flashes and turns back on (pressure switch). It seems the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
