Ask Experts Questions for FREE Help !
Ask
    westlake2's Avatar
    westlake2 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 24, 2011, 03:23 PM
    Where is the angle valve? What does it look like?
    Want to try the suggestion to find out what the noise is from the toilet, but don't know what the angle valve is. Can anyone tell me where it is and what it looks like? Thanks.
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #2

    Feb 24, 2011, 03:47 PM

    It's the shut-off valve going to the tank, look on the left side near the floor. Are you going to adjust it to stop the noise? Might do the trick. Good luck
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #3

    Feb 25, 2011, 09:07 PM

    This is what angle stop looks like at the toilet. It is the valve on the wall. There are several different designs... this is one of them... Hope that helps... Milo
    Attached Images
     
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
    		  
    #4

    Feb 25, 2011, 09:09 PM

    Welcome Milo it been long that you were away, am glad that your back, Thanks.

    John
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #5

    Feb 25, 2011, 09:11 PM

    Thank you John. Doing my best ! Good to be here with you guys, again :-)
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
    		  
    #6

    Feb 25, 2011, 09:12 PM

    Great stay in touch, Thanks.

    John
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Plastic angle valve on copper - What is it? [ 6 Answers ]

In my bathroom the copper stub out is connected to a plastic fitting which has a braided supply line fixed to it. Where the shut-off knob would normally be there is a circular piece of plastic which turns freely. Is this some type of quick connect fitting? I think I have a leak at the...

I need an angle valve [ 6 Answers ]

I just bought a vessel sink that came with one of those tall faucets that mount through a single hole in the vanity. It came with two supply lines that have 5/8" female connectors at the end. The problem is that I can not find a shut off valve with a 5/8" outlet to match my supply lines. I have...

Broken Angle Stop Valve [ 23 Answers ]

Hi, I just joined to hopefully get some help without hiring a plumber. I had a leak in my kitchen faucet and tried to watch YouTube videos about repairing it. However, it looked easier to replace the faucet than the little part within the old one. I moved everything out from under the...

Angle stop valve leak [ 5 Answers ]

I changed all the angle stops in the house. The only one that gave me a problem was the kitchen sink hot water dual outflow (dishwasher). It just weeped the tiniest bit from behind the compression nut. I took it all apart and cut the pipe again for a clean cut, cleaned it up, put on a new...

Angle stop valve [ 3 Answers ]

Do you have any idea on how to install a stop valve under a bathroom sink? Thanks R. Koehn

View more questions Search