Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Corrosion? Of Plastic Stems of Water Shut-off Valves
[ 4 Answers ]
In a condominium constructed about 12-15 years ago in Henderson, NV, I discovered 6 out of 8 under-sink water shut-off valves to have badly corroded valve stems, if that term can be legitimately applied to plastic. The "corrosion" was so bad that one valve had failed causing a flood. Since 75% of...
Replacing Shower Knobs & Stems
[ 2 Answers ]
I am currently renting a condo that the landlord had bought replacement knobs for the shower before moving, but didn't have time to install them. He is out of state. I tried putting them on but they were the wrong ones and I happened to strip the brass parts that the knobs tighten up to. When I...
Diverter valve leak - 3 valve diverter valve?
[ 1 Answers ]
My shower has three knobs and the one in the middle diverts the water flow from the tub spout to the shower. I think that means I have a 3 valve diverter valve, if not please correct me. When I turn the diverter knob so that the water comes out of the shower, there is still significant water...
Installed new bathtub valve stems now "no cold water"
[ 5 Answers ]
I have just replaced both hot and cold valve stems in bathtub. I did them exactly the same and now I can't get the cold water to come out. What can I try to do to fix this problem. Someone said I should have the valve open when installing? I am desperate and exhausted please help!! :(
Gas valve noise on main valve engagement
[ 1 Answers ]
I have a carrier 58gs100ga furnace with a white rodgers 36e93 gas valve. The main gas valve solenoid chatters or rattles for a split second before it stays engaged after the pilot is proved. I just replace the spark/lock out board and the fan board for a different problem. This chatter is... View more questions Search
|