Ask Experts Questions for FREE Help !
Ask
    Dek87's Avatar
    Dek87 Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 22, 2014, 12:34 PM
    Toilet flushing problem
    My standard toilet is having a flushing problem. The first time it is flushed it will fill the bowl with water and slowly drain, never exchanging all the water. The next time it is flushed, it works "normally". There is a vigorous swirling action with the entire bowl emptying. It is not a dual flush model.
    I have tried adjusting the tank water level and plunging the drain, but no difference.
    Any help would be appreciated.

    Dek
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Nov 24, 2014, 08:49 AM
    I have one that most repair plumbers miss.. Look down at the bottom of the bowl. If there is a small hole, then that is a jet that starts the syphon action. If it's clogged the water will just swirl around and slowly go down leaving solids behind. Take your finger,(UGH! ) and run it around the inside of the opening. Over the years minerals build up and cut down on the syphon (flush) action. If it is rough or you feel build up, take a table knife and put a bend in it to get around the curve in the bowl and chip and scrap it clear. Next take a coathanger and clear out the holes around the rim. They start the swirling action. And last, check the water level in the tank. It should be 1/2" below the top of the over flow tube. And speaking of the overflow tube, Make sure the small 1/8" tube from the ballcock to the white overflow tube is connected so it discharges in it and that it's flowing when the ballcock fills. This is what raises the water level in the bowl. For a good solid flush they all have to work together. Hope this helps. Good luck, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Toilet flushing problem [ 16 Answers ]

The main floor toilet when flushing spin in a whirlpool fashion however does not take any of its contents down with it. However after a few flushes it will take it down in a very strong pressured pull. This happens more frequently now even with one sheet of paper in it. Please help!

Toilet having flushing problem [ 10 Answers ]

My downstairs toilet seams to have no flushing power and doesn't fully drain.

Toilet flushing problem. [ 3 Answers ]

I replaced a self contained flush unit (flushmate) with the standard ballcock and flapper. I did not disturb the bowl and now there is no force in the flow from the tank. Also there is actually a hesitation in the tank before the water begins to flow once the flapper is open. Any ideas?

Problem With Toilet Not Flushing And Shower Back Up [ 6 Answers ]

OK I'm in a big situation here. When I flush my toilet it seems as if its going to complete the flush and starts to drain but then it just keeps swirling and filling up and if I do not shut off water to toilet and / or plunge the shower drain it will overflow . When I pump the shower drain the...

Toilet flushing problem [ 3 Answers ]

My toilet flushes correctly sometimes, however, it doesn't other times. It acts like it is clogged, fills the bowl and slowly seeps out. When I plunge to clear the line, it flushes fine once or twice, but then clogs again and slow drains again. Any ideas? This is something that has just...


View more questions Search