I have a Myers jet pump with 2 lines coming out. The pump sits approx 20 feet high from the lake source with a 70 foot run to the lake. Pump kicks in at 20 and rises to 40-42 and will not shut off unless I manually do it and the pressure will hold constant at 40 until the water demand brings it...

I'll summarize what my situation is and what I've done so far. Pressure tank doesn't fill with water Pressure tank air pressure is 28 PSI Tried installing brand new pressure switch and water pressure gauge Water pressure gauge rose to 26 PSI when I turned the pump breaker back on It stays at...

I have installed submersible pump 170 ft deep well for my bilding to store water in the overhead Tank (40 ft) . It was working well for the last 4 years . Now it works well i.e with desired pressure if the voltage is above 250 volts and it takes 7 amp current . However, if the voltage is below 230...

I have installed submersible pump 170 ft deep well for my bilding to store water in the overhead Tank (40 ft) . It was working well for the last 4 years . Now it works well i.e with desired pressure if the voltage is above 250 volts and it takes 7 amp current . However, if the voltage is below 230...

Water pressure began to degrade about 2 week ago the pump continued to run with pressure switch at 60PSI, reduced pressure switch to 55 ans it was OK, after 1 week pump could not achieve 55PSI. I dropped the pressure to 50PSI. It continues to degrade. Does this sound like a bad pump?