Ask Experts Questions for FREE Help !
Ask
    bobcop's Avatar
    bobcop Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 3, 2011, 02:09 PM
    State select model es680dort?
    I just replaced both upper and lower thermostat on the water heater because water was very hot(170degrees) it still is very hot no change whatsoever. The parts I used were state replacement parts.any suggestions? I decided to try the thermostats first as they were not to expensive.. Bob from Maryland
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Mar 4, 2011, 07:12 AM

    Hi Bob...

    I'm afraid that if all was rewired properly then the only next logical step would be to replace the elements, but before doing so I would call State Industries co. and talk to the technical department and see if they can walk you through a troubleshooting guide here.. could save you some time/money... ;)

    When you finally resolve this please pop back and let us know what you found, OK?

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

State Select gas water heater Model PR 650 NRRTL, 50 gallons uni [ 2 Answers ]

I have a State Select gas water heater Model PR 650 NRRTL, 50 gallons unit. Does anyone know which configuration the valves haft to be in, in order to switch from heat to air conditioning? Any advice or help is greatly appreciated.

State Select Wtr Htr Model P64020RT2 - Just Quit Working [ 1 Answers ]

My fiance's State Select water heater (model P64020RT2) just quit working. She lives in a different town than I, so I haven't been able to check it out yet. I had her reset the breaker. No luck. I've read on this site about a reset button. Where is it located, and what else should I get her...

State select model P68220RT, 2 gal capacity, serial # AO1120783, EF .83 [ 0 Answers ]

Water heater came with new house purchased 9 years ago. Approximately 2 years ago the water was briefly very hot then heating was almost non functioning. The 2 thermostats and 2 anodes have been replaced and there is some hot water for a 10 min shower, but then tepid and then cold. Is this an...

Murray select model 405000x8f [ 1 Answers ]

Murray select lawn tractor will turn over when I try to start it, but will not start up.

State Select Water Heater [ 1 Answers ]

I emailed Robershaw who's thermostat is on your water heater, and they said I had to ask you about it, as they design stats for different companies. The stat has hot - very hot on the right side of the dial. Even in the 'hot' setting, the water is too hot. On the left side of the dial are the...

View more questions Search