Ask Experts Questions for FREE Help !
Ask
    sdjaam's Avatar
    sdjaam Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 27, 2016, 11:38 AM
    Sr Mechanical Engineer
    I have a question how over flow of water tank can be prevented if Float Valve fails..
    Or How it is monitored.

    Regards

    Syed
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #2

    Feb 27, 2016, 03:32 PM
    Any tank that has a float valve should have an over flow pipe just in case the float valve fails.
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #3

    Feb 27, 2016, 06:13 PM
    Agree with Harold.

    What plumbing fixture does your question refers to ?

    Back to you

    Milo

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ask the mechanical engineer [ 0 Answers ]

What is the smallest way to get a ball to roll 360 degrees in a socket/casing? Would a ball within a hollow half-ball work or would there be too much friction? If the surfaces were hard, smoothly polished plastic, would this solve the friction problem? Thank you,

Ask a mechanical engineer [ 0 Answers ]

I am a machinist and want to make a thermal actuator for a green house vent. Where can I obtain the proper type of paraffin and what is it's composition?

Ask a mechanical engineer? [ 0 Answers ]

I'm trying to figure out the instantaneous torque required to wheelie my bike in order to develop gearing proper to roll on 2nd/3rd gear wheelies. In first - it will wheelie after 4k rpm with ease. Bike makes 63hp @ 7500, 47 lb*ft tq @ 5900. At 4k, its around 40 ft lb. With the gearing - 1st...

Insi of mechanical engineer(india) oreng ime is equvelnt to B Tech mechanical [ 0 Answers ]

Insi of mechanical engineer(india) ime is equvelnt to Regular B Tech mechanical engineering? After ime we can take addmision in M Tech in regular? Its very hard to clear all subject?

Ask a mechanical engineer [ 0 Answers ]

I have a hobby of making coin rings by tapping a silver coin around its circumference edge with a small hammer while I turn the coin on top of an anvil to flatten the edge until it reaches a desired width and diameter. Then I cut the center out and polish it. I need advice or an idea to make this...


View more questions Search