Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
PVC drain dry-fitting and solvent glueing
[ 10 Answers ]
I am trying to replace all the plumbing in my house with PVC drainpipe. All the 'books' say to dry-fit the system to get the lengths and angles of pipe and fittings and to mark the joints with a "T" pattern marking the seam and fitting angle. The same books say to use these reference marks when...
Compression fitting on soft cooper pipe
[ 5 Answers ]
Is it possible to install a 3/4" valve with compression fitting on soft cooper tubing 3/4" as well? Will it fit? Will it hold? Tank you
Connecting pvc to pvc with no hub fitting
[ 8 Answers ]
My plumber ran into a dilemma when installing rough plumbing for a new basement bathroom. After already laying the pvc piping in place under the broken up concrete floor we found the pvc to cast iron Tee connections leaking. This was discovered after I had filled the opening with a base of gravel...
Connecting PVC to Threaded Copper fitting
[ 2 Answers ]
I have a fitting in a wall which began leaking with mold developing on the wall board. When I took out the wall the culprit was a fitting between a female threaded copper fitting and a male PVC fitting in a hot water line. I initially took out the PVC fitting and fitted the joint with a new fitting...
Can someone please identify this PVC fitting
[ 3 Answers ]
Attached (I hope) is a picture of a fitting I am trying to identify. This fitting joins my PVC washing machine drain pipe to my copper soil pipe. I would like to know what it is called so I can buy another one without sounding like an idiot to the sales folks. Also, I am looking for application... View more questions Search
|