Ask Experts Questions for FREE Help !
Ask
    handymanrich's Avatar
    handymanrich Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 13, 2011, 01:48 PM
    Faucet has loosened on the sink
    Grohe Ladylux installation instruction
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Feb 13, 2011, 07:19 PM
    I believe that model has a single nut that tightens an anchor plate. You will need the installation tool or a deep socket with an extension. Look at the bottom of the faucet and you should see the nut. Tighten turning right.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #3

    Feb 13, 2011, 09:32 PM

    Show us a picture of the faucet and the nut under the counter top.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #4

    Feb 14, 2011, 08:30 AM

    Hi all:

    There are 3 or 4 different Grohe ladylux faucets on the market, but the ones I have worked with tighten from the top.

    Here, remove the spout assembly by lifting hard on the spout and then loosen the spray head and set it off to the side.

    Push the spray hose through the spout and down past the threaded column and then tighten the threaded column CLOCKWISE until the faucet is tight.

    Pull the spray hose up through the spout and attach the head again and then push the spout back down and into place. If you have a plumber's grease then this is a good time to regrease the plastic swivel parts.

    If this doesn't work for you then let us know the exact model of ladylux you have as it could be a little different than as described (but I doubt it), OK?

    Let us know how you make out... ;)

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can't get handle off a Delta Monitor shower faucet? I loosened the allen screw [ 4 Answers ]

I was changing out the fill valve on one of our toilets and when I loosened the coupl [ 0 Answers ]

I was changing out a Fluidmaster fill valve today. When I loosed the coupling nut from the water supply line it broke into two pieced. It is a staight line up from the floor. The opening is wider at the top and I cannot fit the replacement coupling nut over the existing line. Any suggestions?

My AC keeps blowin fuce on the control board [ 4 Answers ]

5 amp fuce keeps blowin on the contol board in my AC furnace, went Itryed to put the AC on

My AC keeps blowin fuce on the control board [ 1 Answers ]

:confused: 5 amp fuce keeps blowin on the contol board in my AC furnace, went Itryed to put the AC on

Can Plastic PVC piping cement be loosened and re-sealed? [ 1 Answers ]

Is there a product that can loosen Plastic PVC piping cement? I have a plumbing pipe with little room to cut and reseal.

View more questions Search