| 
 
 
 
 
 
  Not your question?
  Ask your question
  View similar questions
   
 Add your answer here.Check out some similar questions!
A non-universal tub spout installation
 [ 8 Answers ]
 I am replacing a shower spout in a shower ~30years old. The copper pipe protruding through the wall has a brass fitting which appears to be permanently attached to the copper pipe. I do not see any solder or thread between the two pieces. The brass piece has a few threads near the wall and the... 
Remove old tub cartridge
 [ 0 Answers ]
 I have a moen tub faucet and it's likely 30 years old. I can't get it out. I have a cartridge puller but on my model there is a stainless front piece with 2 protrusions that the handle fit over to control temperature range(?). So the cartridge puller does not work. This is a singel handle system... 
Universal Fit Tub Diverter Spout Replacement
 [ 2 Answers ]
 I recently purchase a PLUMB WORKS-Universal Fit Tub Diverter Spout, replacement. I was able to take to old one off-(Moen), The instructions are totally confusing and of course no 1-800 for assistance, The instructions states make the pipe copper protudes no more than 
Moen cartridge for tub and shower repair
 [ 2 Answers ]
 Can a moen cartridge for controlling water flow to bath and shower be repaired? 
Universal tub spout
 [ 3 Answers ]
 I am trying to replace my tub spout with a universal tub spout and I cannot get the old one loose, any idea's? View more questions Search 
 |