 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Hey Ryan...
First, use a pair of pliers to really grab hold of old handle and see if can rock back and forth gently... it may or may not loosen it. Next, you could try and purchase a HANDLE PULLER (see picture)... sold at home depot and Lowe's. The screw is removed from the handle itself and the tool is inserted into handle so that the arms go behind thee handle. Then you tighten the handle puller and with any luck handle will pop off. Finally, if that doesn't work... and it doesn't always work with the SYMMONS handles.. you may have to break the handle off by rocking handle back and forth and finally SNAPPING the end of the symmons spindle assembly. This is worst case and should only be done as last resort because it will require you to replace the entire spindle assembly as well as the handle! This will require you to shut the main water supply to the house. This method is usually reserved for times where the spindle assembly needs to be replaced anyway! Let us know if have any questions... Good luck. MARK |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hi - I am trying to replace washer on the bottom of a stem because shower leaks. It's not hot or cold, but on/off handle in the middle. Anyway, I bought the tool to get the packing nut off, but now I can't budge the stem. Is there a trick to it? Maybe I don't have enough strength in my hands. ...
I am trying to change the showerhead and discovered that the current showerhead has a ball tip not threads. I bought a new shower arm pipe with threads on both sides but can't get the old arm pipe out! Any tips or tricks for removing a pipe that is stuck? I can't seem to get a good grip with my...
Hello. My hot water shower knob has been stuck for months and the only way I can turn it is buy using channel locks. Though I don't think this has anything to do with it, the knobs themselves used to fall off all the time, and so during a weak moment I epoxied them into place. I know, not a...
I'm trying to remove the shower stem so that I can take it to a home improvement store and find a replacement. I have a shower stem socket that I am attempting to remove the bonnet nut with, but it won't budge at all, no matter how much leverage I try to apply to it! I'm not sure if maybe I am just...
I am trying to install a new shower head but the old one is stuck. I've removed the shower head itself but there is a ball nut that allowed the shower head to swivel attached to the pipe from the wall that will not come off. I have tried WD-40 but it will not come off. The shower head was installed...
View more questions Search
|
