Ask Experts Questions for FREE Help !
Ask
    bbglme1's Avatar
    bbglme1 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 15, 2006, 04:24 AM
    Toilet flange
    I am installing tile in bathroom so the toilet flange is now about approx. 1/2" below the tile. Do I have to remove the toilet flange or are there extensions?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Feb 15, 2006, 05:13 AM
    I think you'll be able to use the flange where it is.
    Pick up a set of longer closet bolts and a wax ring with a funnel attached. You may wish to purchase a additional wax ring in case one won't extend up far enough. TIP: If you use two wax seals, tale a knife and bevel the wax from the inside out. That way any extra wax will be forced to the outsode instead of inside where it could block the flush. Good luck, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What toilet flange to use? [ 9 Answers ]

I am remodeling a bathroom in an old house. The floors are concrete, and right now there is just what looks to be a cast-iron waste line that runs up through the concrete for the toilet. The inside opening of the pipe is 3 1/2" in diameter. What flange do you recommend for this? I can only find 3"...

Toilet flange [ 1 Answers ]

Hello, I realized as I was installing the subfloor in my new bathroom that I had cut off the pvc to short. It is slightly lower that the subfloor. Is there a longer flange which will solve this problem or should I remove the floor add a coupling and more pvc to raise the height? Thanks, m2

Toilet flange [ 3 Answers ]

Hi, I'm putting a new floor in the bathroom. The tolet flange is higher by 1/4 in on one side and 1/2 in on the other above the floor I'm going to put ceramic tile down. Do I need to level it out or bring the floor up around the flange? Thanks Tim

Toilet flange HELP! [ 3 Answers ]

HI, I need some good professional advise. My toilet was leaking and I removed it to find that the toilet flange was broken on one side. The flange and lower pipe appear to be cast iron 4 inch. I must replace some of the damaged flooring but am at a loss as to how to remove the cast iron flange from...

Toilet flange [ 5 Answers ]

I am in the process of re-settin my toilet, It is located in the basement and the toilet flange sits on top of the ceramic tile. It is not flush with the tile. I have reset the toilet three times using various thickness of wax. These only last so long. I have purchased a wax free bowl gasket...


View more questions Search