The shower is dripping and I am trying to get to the stem by removing the handle. I can see a set screw recessed into the bottom of the handle. I have tried an allen wrench but bent it without any success.

:eek: I have an unknown 3 handle shower with the middle handle broken off with the screw and part of the pipe that it fits into, in it! How do I fix this now? Thanks!

I have a Kohler one handle shower valve that does not permit me to get hot enough water. Water heat is OK and hot water is available in other bathrooms. How do I change the valve to get hotter water. Admiral

I'm replacing my whole shower. There is a shower head and a handle. I've removed the handle and note a round copper stem with a flat bottom, sticking out from the center of the hot/cold connector. It is about 1/4" diameter. Is this a standard set up? Will any replacement valve fit on it or are...

The single handle shower control knob needs to be turned slightly on to prevent dripping at the faucet when turned off. I also can't seem to get the water hot enough for my shower. Am I just catching the water heater at a "down" cycle or is something deteriorating in the handle mechanism?