Search:

Thanks to all for these great answers.

Does this solution eliminate the need for the Desanco fitting? If so, how would I connect the 1 1/2" x Close gal (or brass) nipple Male thread to the 1 1/2" chrome trap assembly with metal nuts and...

Thanks again.

Thanks for the quick reply. Can you make an educated guess as to if the male thread from the PVC into the metal stub is most likely 1 1/2" diameter? When I physically measure it I get between 1...

How do I replace PVC p-trap and waste arm with chrome/brass one for a decorative drain to complement a pedestal sink? The PVC is screwed to the metal (galvnaized steel?) stub out at the wall. I...

For a cast iron closet/toilet flange, should the Johnny bolts used to attach the toilet to the flange be made of brass or stainless steel or other? If brass, will it eventually corrode the cast iron...

There is a large gap between the toilet closet flange/drain pipe and the concret floor. Water had settled in that gap due to it leaking through the vinyl tiles after floor cleaning, etc. All of the...

Thanks Tom. I appreciated the picture too.

Where does the plumber adjust the raiser position? Does he shift the trap itself?

If he uses PVC in the repair, where would he cut out the copper and how would he join the new PVC to the...

A new Florestone acrylic shower receptor was installed in a 2nd floor shower as part of a shower wall retiling project. The drain is 2" copper. The receptor was installed but the rubber seal that...