Search:

Hi,
Let's first start on where is the softener located?
If it is close to any heat source this could be your problem as all sears units are dry storage ( leaves a little water in the tank). The...

Sounds like the drive belt is either loose or worn out, a simple fix either way.

Here is what I had to do, go to your neighbors and see if they will sign a letter stating that it does not disturb them, I had the same issue on my ram after putting on the duals and one of my (uhm)...

Yes there is, after installing softener for over 35 years I have cmae up with the following.
Get yourself a length of 1" cpvc piping, some elbows to go with it, large hose clamps. You have to...

No this is not normal, if it is possible you will have to increase the final rinse and that will take care of your rusty water after regeneration cycles. It would help me if you could tell the brand...

That is a culligan push bar by-pass, if you have not pushed the by-pass fully over it will make a noise. I do recommend removing the by-pass and coupling the pipes back together and see how that...

You're welcome and good luck... :-)

Hi,
And don't forget to flush out the old fluid and put fresh fluid in and bleed the system completely.

I have found that the rotors get glazed from normal wear and tear, take your rims off and clean the rotors with break cleaner and this will fix it till they get glazed again.
Good Luck
Mark

There is not two flasher units, your hearing your relay clicking. While in your driveway raise your hood and try locating the click with the signals on. It sounds like a short in your wiring. (either...

Yep, that's a damper door and you can get it fixed at Master radiator if you have one near you for less then the dealer. I have two rams and will not take them to the dealer for this anymore. (way to...

It has to do with the vent door located in your dash, it is made of plastic and is starting to break. If you have a master radiator shop near you they can fix this for you. If not you'll have to go...

P.S. If you are having trouble turning the knob to manually regenerate this unit , look for the piston rebuild kit and don't forget the refill piston. (sometimes referred to as the brine valve)
Mark

You can get the part on-line at watervalue.com, this is a common problem for this type of unit , and yes those motors can and will burn themselves out. I have replaced a ton of them due to this. (35...

Hi,
With the limited information provided I would start by checking a few things,
1. Is the distributor inside the softener cracked?
2. Is the unit old and just the resin breaking down?
3. Is it...

Hi,
This is not so much as an answer as to a Help request also, I am having the same issue with my coleman, already replaced the flame sensor to no avail. The burner starts up and shuts right back...