Search:
Type: Posts; User: eigenheerc
Search:
Search took 0.00 seconds.
-
I found out that the insided ball bearing of my 91 honda accord distributor is shot and was told by honda that they don't fix it, they just replace the entire distributor. Since paying $450 bucks...
-
I want to put in a laminate floor over the square hole in the basement that accesses the main sewer cleanout (3" PVC). What is the easiest and most recommendable way of doing that enabling access as...
-
Cool. Thank you for your advise, Tom.
-
Whoever installed the water softener in my house (done with the previous owner) obviously wasn't the sharpest knife in the kitchen because they installed the sediment filter AFTER the water softener...
-
The main horizontal 3" sewer line that goes out to the septic system is about 6" below the basement concrete which will not give me enough height to have a cleanout (already existing wye at a 45...
-
I think normally a 3" tee has about an inch and a quarter depth to join with the actual pipe, how much of that would be the minimum I can get away with and still have a good bond?
-
Ok, I'm all new to this forum; my apologies for not giving you enough information! The soil stack (didn't know the difference between a soil stack and a vent stack until you explained it) is a...
-
Ok, I'm all new to this forum; my apologies for not giving you enough information! The soil stack (didn't know the difference between a soil stack and a vent stack until you explained it) is a...
-
Are there any tricks to put a 3" Tee into the main vent stack to add a lavatory? I don't think I can lift the top part of the stack up or push the bottom part of the stack down once I cut it in half...
-
I'm finishing the basement and have to add a bath tub as well as a toilet. My plan is to have a horizontal 3" tee, one side going to the toilet (about 16"), the second side to a 1 1/2" reducer which...
|