Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Cast Iron Kitchen Stack
[ 3 Answers ]
I'm replacing the drain stack in my kitchen. I have the wallboard removed and exposed is the cast iron stack from the basement. At the top of that stack about 19" above floor level (inside the wall) is the connector or hub that receives a vertical “T”. Entering the “T” horizontally was the old P...
How can I remove a Brass/Copper fitting on a cast iron drain pipe
[ 1 Answers ]
After removing a copper drain pipe there is a fitting on the cast iron drain pipe where the copper pipe was sweated to. I can see threads and I heated it with a torch but it is very stubborn and does not want to move. How can I remove this more heat? Or should I look for a copper connector with...
Getting Cast Iron to Seal Well with PVC
[ 1 Answers ]
I also have a similar problem. I have a second story bathroom and after a heavy rain there's water on the cabinets below that bathroom. The water is from outside the wood of the cabinet, so I can't tell if it's rain water or water from the sink or toilet (no shower in the upstairs bathroom)....
How do I seal pvc toilet flange to cast iron drain pipe
[ 1 Answers ]
Just bought a house with damaged toilet. Existing plumbing is pvc toilet flange inserted into cast iron drain line. The flange is loose and needs to be refastened to the floor, subfloor condition permitting . How do I seal the pvc toilet flange to cast iron drain pipe to ensure no sewer gas leak?
Cast iron vent stack
[ 7 Answers ]
I'm installiing a new basement bathroom and when running a vent stack I would like to tap into the existing cast iron with PVC using a saddle on the cast. My question is what method is used to cut a hole in the cast iron, where I wish to place the saddle and connect the PVC. View more questions Search
|