I have just installed a new valve, and I'm waiting for the device to go behind it (therefore no back pressure). Trouble is when fully shut it still lets out about a gallon in 7 hours. Does anyone know if this is normal or a defective valve?
Add your answer here.
Check out some similar questions!
How do I stop saddle valve from leaking [ 1 Answers ]
After turning off the valve to remove old plastic tubing and add copper line, when I turned the valve back on, it started to leak out of the point where the handle stem goes into the main body.
Leaky Saddle Valve [ 3 Answers ]
I think I've screwed up. Last night I replaced a faucet in my kitchen. In order to get to the cold supply line I very slightly bent a copper tube out of the way. That tube is attached to my instant hot on one end and a saddle valve on the other. The end where the copper tube goes into the...
Saddle valve [ 2 Answers ]
I'm trying to install a saddle valve for an icemaker/refrigerator. It says the line should be 1/2 inch that the saddle valve goes on. Can it be 3/8 inch instead?
Aquapex with saddle valve? [ 9 Answers ]
Hello, I was wondering if someone could help me out. I bought a fridge that has water dispensing unit and I want to plumb it in. I bought an install kit that came with small copper pipe as well as a saddle valve. I have 1/2 inch aquapex run throughout my house, I was wondering is the saddle valve...
View more questions Search