Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bathroom vent pipe
[ 3 Answers ]
I would like to move a wall in my bathroom however there is a 3 or 4 " copper vent pipe. Is it within the established building codes to make a bend either 45 or 90 degree bend and re-attached to the existing vent pipe in the attic? I am located in Ontario Canada Thank you in advance for your reply
Bathroom vent pipe
[ 1 Answers ]
I want to install an inset medicine chest. A 2" pvc pipe is in the way. If this is the vent pipe can I simple add elbows and bend around the chest?
Running a vent to bathroom from central ac/heat
[ 1 Answers ]
I want to run a 4" vent to my bathroom from the central ac. It is located in the attic and above the bathroom. I just replaced all the ductwork for the whole house. It's probably about less than 4' to the bathroom ceiling. Do I cut into the box and install a 4" collar and run the ductwork or use...
Bathroom vent pipe
[ 1 Answers ]
Our bathroom vent pipe which extends through the ceiling, through the unheated attic space and through the roof has been leaking after a shower. The is a bend in the pvc pipe and it is leaking at the joint to the 90 degree bend. Since it is difficult to access due to the slope of the roof, we are...
Bathroom Vent Pipe
[ 1 Answers ]
Is It Ok To Drain My Central Ac Unit Into My 4" Bath Vent Pipe And Should There Be Water In That Pipe. The Ac Guys Did That Because The Other Ac Pipe Was Cloged. View more questions Search
|