Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How to replace Symmons diverter Handle part T-30?
[ 6 Answers ]
This piece is made of plasic and broke off at the 90* neck angle. (at least it is stuck on shower mode which, if it had to break, is what I would prefer.) I have ID'd the part # but have a couple of quesitons about replacing it. First, how difficult is this for the average joe? I have a diagram...
Symmons Temptrol: Repair or Replace
[ 3 Answers ]
Tried to install a new trim kit on a 20 year old Symmons Temptrol shower/tub valve, but broke the end off the spindle (TA-10). Currently debating on the overall benefits of - repairing the old Temptrol (new spindle, maybe need new washers and/or seals) - replace with new unit (which...
Symmons shower diverter spindle
[ 0 Answers ]
Hi,I have just replaced my Symmons shower diverter spindle again(TA-25A)because of a leak and now have a new problem. I have to replace this diverter spindle every year or so because the plastic on the end by the o-ring cracks and it leaks water down through the first floor ceiling.The problem now...
How do you replace the Symmons temprol diverter
[ 1 Answers ]
How do you replace the temprol diverter in a Symmons single valve shower/tub assembly?
How to replace symmons spindle
[ 1 Answers ]
How do you remove old symmons spinde and replace it with a new spindle and diverter Handle?? View more questions Search
|