Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Leaky Compression Shut-Off Valve
[ 2 Answers ]
I recently replaced an old, leaky shut-off valve with a compression shut-off valve. I cut off the copper pipe cleanly and made sure the end was clean and burr free. After tightening the nut as instructed, I still had a leak from where the valve connects to the stub. I've adjusted it a couple of...
20.5hp briggs, compression release valve?
[ 8 Answers ]
Do these engine have a valve to release compression to make it start easier? I think mine is stuck shut cause its real hard to turn over
Water supply valve leaking
[ 3 Answers ]
Friends- I asked about water supply valve leaking a couple of weeks ago. Just got to repairing it. With some difficulty I got the packing around the stem and wonder of wonders the valve does not leak. Thank you. However, when I turned on the water supply to the house (There was no other turn...
Water supply valve leaking
[ 2 Answers ]
Friends- An indoor water supply valve to an outdoor spicket is leaking around the base of the stem when I open the valve to use the outdoor faucet. Is it most likely from a deteriorated washer or O-ring? Is this corrected by turning off the house water supply, opening the outdoor faucet to...
Supply valve replacement
[ 4 Answers ]
What is the best way to remove the nut and compression fitting on a sink supply valve? View more questions Search
|