| 
 
 
  Not your question?
  Ask your question
  View similar questions
   
 Add your answer here.Check out some similar questions!
Wall Mounted Toilet- General Questions
 [ 5 Answers ]
 Howdy all, I'm on a roll today with the questions... The baseboard of my bathroom started deteriorating under my wall mounted toilet (hangs off the wall- nothing touching the ground). I assume the wax ring is ka-put. I need to replace it. I have a special wax ring made for wall hung... 
Toilet continuously running when faucet used
 [ 9 Answers ]
 My toilet was running continuously so I turned off the water valve. When I turned back on the water valve the toilet didn't run. When I flushed the toilet, it flushed normally and didn't run. Many hours went by w/ no running. BUT when I turned on the cold water faucet near the toilet, the... 
Banging/Tapping Noise when turning on faucet/flushing toilet
 [ 3 Answers ]
 Hi guys! In addition to my little problem with my toilet posted in another thread (can fix it easily), I have another issue. Every time I use the upstairs shower/toilets/sink, when running water, a loud banging/tapping noise appears. When you turn it off, the banging noise still appears... 
Toilet drain questions
 [ 3 Answers ]
 We're installing a new bathroom on the third floor of our old house. The toilet is on the wall opposite the 3” stack. The 3” drainpipe from the toilet will run horizontally about 8 feet to where it will pick up the 2” lavatory drain (vented) in a 3x3x2 wye. The 3” drain will then turn and drop... 
Low hot water pressure from kichen faucet only- 1 handle faucet
 [ 7 Answers ]
 Hi. My question is similar to one asked a few posts ago except this is a 1 handle faucet. I plan on maintaining the boiler from now on but I have to fix the flow problem first. I disconnected the hot water supply line to the faucet and the pressure is excellent so I assume the problem is in the... View more questions Search 
 |