Ask Experts Questions for FREE Help !
Ask
    Sundial's Avatar
    Sundial Posts: 2, Reputation: 1
    New Member
     
    #1

    Jan 4, 2010, 10:38 PM
    Pressure tank reads zero
    I don't have any water coming from my well. It is way below freezing outside, but I have a heat tape on my well head that has always worked and feels warm. I added a heat lamp late this afternoon. I have the kitchen faucet wide open and still no water. I noticed that the gauge for the pressure tank is reading zero. Is this because the well or lines leading to the house are still frozen, or could it be that the pressure tank has a broken bladder and this is why I don't have any water?

Check out some similar questions!

New pressure tank one intake; old tank has 2 [ 2 Answers ]

My pump is cycling on/off rapidly. I want to replace old 33 gal. bladder tank with used one.Leaks at air inlet and will not hold air in bladder. My old tank has two pipes, one intake from the pump and one goes to service the house. The newer tank(air-e-tainer 33 gal) only has one inlet total. ...

Do I need to install a jet pump, a pressure tank and a holding tank? [ 6 Answers ]

I have a new home with nothing but the 1inch well pipe stemed through the cellar wall. My house is not on town supply line. Do I need to install a jet pump that goes to the pressure tank which then sends water ot a holding tank? Or is the pressure tank by itself all that I would need? Or a...

Deep well, pressure tank/switch not building pressure [ 13 Answers ]

The only way I have water pressure is to leave the power on! I have replaced the 5 gallon pressure tank (28psi when void of water)/fittings/pressure gauge and tried 3 new 30/50 pressure switches and the problem remains the same. With the power off, the pressure drops to 0 (not 30). When I...

Oil pressure gauge reads zero. [ 1 Answers ]

Hi I have a 1995 jeep wrangler that I just purchased. The oil pressure gauge reads 80 pounds all the time I opened the hood and noticed the eletrical plug was off the oil pressure sending unit. I reinstalled connector and now oil pressure reads zero at idle or 3000 rpm. Do you think sending unit...

Tank Pressure vs Pump Cut Out Pressure for Well [ 1 Answers ]

I am trying to increase my water system pressure to the minimum required 40 PSI to feed my reverse osmosis drinking water filter. However, the 33 gallon pressure tank for my well pump system says it is pre-charged at 30 PSI and that the cut in pressure for my pump should be set equal to that 30...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.