My propane furnace G6RC has no visible flame and the red light either stays on or flashes 3 times in a row and then the furnace shuts off and tries to restart

I am trying to light the pilot light on my older Maytag dryer. I cannot find any button to push while lighting the light area. All I see are screws, and electrical wire connections. The dryer does not heat and I assume that it is old enough to have a pilot that needs lighting. Thanks

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

We have a 20 year old CArrier furnace, Series 100, Model 55DRCO-45CB. It is not heating even though the temperature gauge on the wall is on and set to heat, 70 degrees. We checked the fuse. It's fine. We don't see any pilot light--in fact, we don't even know where to look for the pilot...

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...