Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
New hot water heater installed, but no hot water pressure. Plenty of cold water?
[ 11 Answers ]
Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....
Water Heater problems, no water flow after pressure valve change
[ 4 Answers ]
I changed my pressure release valve, now I can not hot water flw in my house.
Brand new water heater: Starts hot, then water gets cold after few seconds
[ 9 Answers ]
We just moved into a brand new condo which has its own water heater. We went to take a shower this morning and the first few seconds of the shower were very hot, then it went cold after 10 seconds. We tried again after half an hour, same thing. There was enough hot water for my husband to shave but...
No water in hot or cold bathroom sink after flushing my gas hot water heater
[ 5 Answers ]
Thank you. I flushed my hot water heater last night. I only turned the cold water intake to the heater off and on BUT now, after the flush, my second floor bathroom sink faucets (both hot and cold) don't work at all. The shower and the tub in the bathroom work but NOT the sink- HELP! Thanks so...
Low water flow from bath faucet after new water heater
[ 7 Answers ]
I just had my water heater replaced by a plumber. Now the hot water flow and pressure is about 1/4th of what it used to be at the upstairs tub faucet. Other faucets in the same bath seem low as well but it is hard to tell. The bath tub faucet had great flow before and would fill the tub in 5... View more questions Search
|