Ask Experts Questions for FREE Help !
Ask
    cjbender's Avatar
    cjbender Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 31, 2006, 06:03 AM
    New Kitchen sink installation
    I have just installed a new stainless steel kitchen sink, and I am having a problem with the two front corners being raised. The clamps that came with the sink do not hook into the corners which is where I need them the most.

    How can I get the two front edges to lay down?
    omzig's Avatar
    omzig Posts: 119, Reputation: 19
    Junior Member
    		  
    #2

    Oct 31, 2006, 06:40 AM
    Sometimes it helps to put something under the clamp screws as a spacer to give a little tighter fit. What I have done before is cut a strip of Masonite about 3/8" wide to put between the sink bottom and all of the screws on a side.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kitchen Faucet Diverter Installation [ 1 Answers ]

We recently installed a new Corrego Kitchen Faucet Model #F87B4500BNC, and found we had very low pressure, so we called the company and they said that we needed a diverter so they mailed it to us. No instructions came with the diverter, so we need to know where and how to install the diverter. ...

Kitchen Sink/Laundry Sink Drain Vent Non-exist [ 3 Answers ]

The set-up from kitchen sink leading down to drain to basement: 1. Kitchen sink - (R side) - connected to a P drain I think you call it -PVC-, connected to a "metal" T, which has a Studer vent gizmo attached to the top of it, then draining into a metal pipe straight down to the drain in the...

New shower sink and toilet installation [ 1 Answers ]

I need to install a new bathroom for my elderly mother. I have 2 possible locations in mind one is at the back of the house which would place ths bathroom very close to the original bath the other would be in the front of the house approx 25 ft away from existing. Will I need to install a new vent...

Corner Kitchen Sink installation [ 3 Answers ]

Hi! I'm back after months of making slow progress on my kitchen remodel. I'm nearly ready to install the sink, and have run into a problem that I COULD have forseen if I was any good at "planning"! :) While shopping for a sink, I found this very neat design that fits in the corner: a large...

Kitchen sink [ 1 Answers ]

Why do I need "backflow" protectors ?

View more questions Search