| 
 
 
 
  Not your question?
  Ask your question
  View similar questions
   
 Add your answer here.Check out some similar questions!
Installing Shower Arm
 [ 2 Answers ]
 I have a shower downstairs where a 6" shower arm comes out of a wall that was connected to a 90 degree threaded joint inside the wall. My roommate without my permission took out the 6" arm and installed an 'S' arm. She did a poor job (did not take out the old thread/puddy, didn't put in new pipe... 
Installing a tub/shower in a preexisting shower only
 [ 2 Answers ]
 I'm having trouble installing a tub 60 inches in a 60 inch in length space. Is there a trick to getting it in this space? Thank you mike also it is extra deep tub does this make a difference?? 
Installing hand-held shower on fiberglass shower
 [ 2 Answers ]
 I am installing onto a fiberglass shower a rain fall shower system that has a separate hand-held shower head. The two options to install are using a suction bracket or using the bracket with a screw. Can I drill into the fiberglass to use an anchor and screw? Thanks very much. Cheryl 
Installing new shower pan
 [ 1 Answers ]
 I am installing a new shower pan since there weren't any in my house built in 1985. I was reading various literature and it says before I put in my sloped concrete I need to put down a liner of roofing felt. Do I need to do that over concrete subfloor or just a wooden subfloor? Please help. 
Installing a New Shower
 [ 3 Answers ]
 I have a stand alone shower in my master bath - 2nd floor - that has a small leak. I can't see where it is leaking the corners of the dry wall by the base were getting wet. I noticed that the rubber pieces holding the glass in place had either shrunk or were cut to short to fit the space and... View more questions Search 
 |