Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Disassembling hubbed cast iron -- lead and oakum
[ 9 Answers ]
Hey folks, I'm taking apart part of the cast iron main stack in my house (3" hubbed service-weight) to replace a leaky fitting. I've used a galvanized saddle clamp, and am pretty happy with the support/blocking/pre-load i have on the main stack, so it's time to take apart the joints and bust...
Oakum and Plastic or Lead with Cast Iron
[ 1 Answers ]
Has anyone used plastic filler with Oakum in cast iron joints? I would like to know your opinion on using plastic, and if you like it, what name or brand have you used? Thank you. J
Cast Iron Lead sealed plumbing
[ 1 Answers ]
I have an older home that has a vented stand cast iron plumbing (4-6" diameter), and the joints are sealed with lead. I need to rotate one tee joint (runnuig vertically). Do I have to heat the lead to a molten state to allow rotation? I have never worked with lead sealed pipe and while this...
Lead Pipe/cast iron
[ 4 Answers ]
Hi! I just removed drywall to fix a drain from a bathroom sink. I found 1.5" soft lead pipe from the p-trap to a 3" hub on the cast iron stack. Can I use some kind of coupler from the lead pipe to new plastic or do I need to replace the entire length of pipe? If I need to replace, what's a good...
Removing galv fitting from cast iron pipe
[ 4 Answers ]
What is the best way to remove a threaded stuck lead fitting from a cast iron section? The fitting was from a lead sink drain pipe and it connected to the cast pipe at the toilet elbow. I tried a pipe wrench and a hammer to try to budge it but no go. I want to thread new PVC into the section of... View more questions Search
|