I think I messed up the standard adjustment of the Utilitech Pump which is set at 20/40 from the factory. Now I can't get the pump to stay on since I adjusted it? Curious if anyone knew any tricks?

I have a drilled well. The expansion tank and pump controls and whole house canister filter are all down in the crawlspace. A space that as I get older, I like to visit less and less. I want to move the whole house filter, the pressure control switch and the pressure gauge up into a room on the...

Testing the pressure control switch I found that the ground had 1/2 volt. Just wondering why that would be?

Ok, I am pulling my hair out. I changed my pressure control switch(square D). Because my pump wouldn't kick back on after getting below 30#. (I have a 30-50) It was 15 years old and I have very hard water so I figure it was time. Still the same result pump cuts off at 50 but does not kick back...

My well pump is about 150 yards from my home where I want to install a bladder tank and pressure switch in my basement. I have been told that I can not do this because of the distance to my pump. I have a submersible well pump and the only place I have to put the bladder tank is in my basement. ...