Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
American standard stem
[ 1 Answers ]
I replaced two american standard stems(with a "top cap" seal). The cold is fine, but the hot has little flow with the new stem and seat.The old stem was wearing into the seat, and the top half of the seal on the stem was separated. I had to put the old stem and seat has well as the broken seal to...
American Standard Diverter Stem Stuck
[ 16 Answers ]
I have a circa 1965 AS Heritage in the wall 3-handle tub/shower fixture. I believe it's a Hertitage Model "N 1012" or N 1020". The diverter works spoaratically - the water flows to the shower, but then abruptly stops. With the diverter arrow pointing down for the tub water flows just fine. The...
Leaking American Standard valve stem
[ 2 Answers ]
I have a new American Standard valve stem that is leaking from around the central shaft (in case my attached image doesn't work, see http://neilnowatzki.com/graphics/plumbing/valveStem.jpg). It leaks when the valve is partially open, but not when fully closed or fully open. No water leaks from the...
American Standard Stem
[ 1 Answers ]
I took my American Standard Stem in to the Home Depot. They compared to to others and said that it was a 2C-14C. Then they gave me replacement Nu-Seal washers and said that there is no seat for this. Is that possible? Here it is with the new washer attached.
Repairing American Standard Shower stem
[ 1 Answers ]
I have an American Standard Shower Stem (cold) that needs repair. However, I can not seem to disconnect it from the pipe. I will attach a picture of the stem and perhaps someone could tell me what wrench to use. Thanks! View more questions Search
|