Ask Experts Questions for FREE Help !
Ask
    toluwatope's Avatar
    toluwatope Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 14, 2011, 09:56 AM
    How do you regulate the presuure of a submersible pum
    Submersible pump regulation
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #2

    Feb 14, 2011, 01:13 PM

    How to adjust water pump pressure, pump cut-on pressure and pump cut-off pressure - private pump and well system do-it-yourself repairs

    Check out the site above. Great description of a not very difficult process.
    renerabril's Avatar
    renerabril Posts: 7, Reputation: 1
    New Member
    		  
    #3

    Mar 12, 2011, 09:33 AM
    We had one for years in New York, I know of no way to do this. I suppose there may now be one available that has a regulater. We replace ours from in the basement to submersible to get more pressure. It reall didn't help all that much... Good Luck...
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #4

    Mar 12, 2011, 02:27 PM

    Ren, I'm not sure what you are talking about. If a pump has sufficient water and is in good working order, you can certainly adjust pressure with the switch. It has been done countless times. Now, you might have a problem with not being able to get sufficient pressure from your pump. That's a separate problem. Is that the case with you?
    renerabril's Avatar
    renerabril Posts: 7, Reputation: 1
    New Member
    		  
    #5

    Mar 13, 2011, 10:26 AM
    Comment on jlisenbe's post
    I replaced an above ground pump with a submersible. Our pressure was adequate. I did not know you can adjust the
    Pressure on the pump by using the switch. Thanks.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Thermostat will not regulate the temperature [ 1 Answers ]

I have a braeburn 5000 thermostat. I have programmed it, but when it reaches the given temperature say 65, it doesn't cut off and start up when it goes below the set temperature. The furnace continues to run until I switch off the heat. I replaced the batteries and put in a new air filter...

Son's father moved out now but wants to regulate [ 7 Answers ]

I have been living with my child's father for 7 years with a break in between for 1.5 years... when I moved out with our child 1. years ago we had child support and custody in place and when we moved back in together we kept the custody arrangements and support order until he lost his job last...

Pum primeing [ 1 Answers ]

I recentaly replaced a fresh water tank in my 5th wheel camper--now I can't get the pump to prime. Made sure connections were correct-all OK! Anyone with an idea? Thanks

Problems with my fuel pum electric system I don [ 1 Answers ]

I just replaced the fuel pum because I thougth tha the older fuel pump was bad but I replaced and the car keep doing the same thing after a while the fuel pressure goes down I donīt know if is because of the oil pressure sender unit isnīt working right .:confused: where is located the fuel pump...

How to regulate box size? [ 1 Answers ]

Dear All, Mostly concerned with MS Word. When working with multiple documents, when I move between documents, sometimes the program brings it back in full size and sometimes in reduced size. Is there a way to command the program to always bring it up in the same size? And the same question...

View more questions Search