Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Pressure switch operation
[ 12 Answers ]
My pumptrol pressure switch 9013FSG2J21 is set at 75 psi cut off and 45 psi cut on. When opening a 1/2 inch spigot and allowing water to flow freely my water pressure falls from 75 psi to 45 psi, the motor turns on and the pressure begins to build and will build all the way back up to 75 psi, the...
How to set up water heater to pressure tank
[ 1 Answers ]
We are having a shallow well dug this spring up in Maine and are looking for information on how to install the main water pipe to the pressure tank to the hot water tank with plumbing to go to our shower, bath sink and kitchen sink. We do have basic plumbing skills.
Bladder Tank / Pressure Switch Set Up
[ 3 Answers ]
Hello All I purchased a new 44gallon pressure tank and attempted to install it myself. After all connections had been made to the pump and to the rest of the home I turned power on to the pump. After a while of run time I learned that the pump was not actually pumping water into the tank? I then...
Proper air conditioning operation
[ 2 Answers ]
How long in general should it take an air pump ac or central ac to lower the temperature one degree? My heat pump ac takes one-half hour to do so. Is there an average time that is about right? Thanks.
Proper DWV connections for this set up
[ 3 Answers ]
Is this do-able and how would I connect the drain DWV? Basically, I would like to put a urinal where the shower was intended to be in my basement. http://bergsonline.com/wallsetup.jpg View more questions Search
|