Ask Experts Questions for FREE Help !
Ask
    heber's Avatar
    heber Posts: 3, Reputation: 1
    New Member
     
    #1

    Sep 17, 2014, 05:01 PM
    Help with hot water pressure
    I have hot water all over the house and in the master bedroom sink, but no presurre in the master bedroom tub, I have replaced the valve cartridge, crawl under house to check for leaks, I'm at a stand still, any help would be greatly appreciated.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #2

    Sep 17, 2014, 05:29 PM
    When you replaced the tub valve cartridge, did you flush the lines to clear any debris.
    heber's Avatar
    heber Posts: 3, Reputation: 1
    New Member
     
    #3

    Sep 17, 2014, 06:05 PM
    I let the water run , How do you recomed I flush the lines for the tub?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #4

    Sep 17, 2014, 06:20 PM
    You have a volume issue, it just seems like pressure is the problem. Remove that cartridge AFTER you shut down your main and allow the pressure to be relieved. With the cartdige out cover the opening with a big towel and have someone else open the main just for about 5 seconds. It may get messy but that will clear out the lines. Reinstall the cartidge, turn the main on and test. Letus know how it is

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kohler K-304-K valve has plenty of cold water pressure, but no hot water pressure [ 1 Answers ]

So I just installed a K-304-k into a house. The house has been vacant for about 15 months now, so no one has been using the water. I came in and replaced the valve, and closed up the wall. I installed all the fixtures, and sure enough, no hot water. It comes out in a slow trickle. Here are...

New hot water heater installed, but no hot water pressure. Plenty of cold water? [ 11 Answers ]

Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....

No hot water pressure/hot water after turning main water off/on and draining water [ 5 Answers ]

I turned the main water off to our home to remove our water softener and ran the water in the kitchen and both bathrooms until no water came out. Now there is no hot water pressure or hot water at all sinks after turning the main water back on, but there is normal cold water and cold water...

Low hot water pressure on a kitchen sink, good cold water pressure [ 4 Answers ]

I have a single faucet sink where the cold water pressure is fine and all other sinks have good hot and cold water pressure. I replaced the kitchen faucet two years ago along with new lines. As of late I'm getting very little hot water pressure along with having to run the water for about 10...

I have very low hot water pressure from my hot water heafrom an electric water heater [ 0 Answers ]

I have very low water pressure from my hot water heater. I can't find anything wrong.. any ideas?


View more questions Search