I am building a 16' diameter conference table with a 10' diameter center. The table top sits on a base, but the customer wants access to the center area for vacuuming and cleaning. I'm trying to figure out how to accomplish this! I have a pretty good sized budjet for the project, but I want to be...

OK, it's time to rebuild. I've purchased the 3" donut, but it does not appear that it will create a water-tight seal between itself and the hub, even after I slide the 1.5" PVC pipe into the donut. My concern is without a water tight seal, this upstairs bathroom sink drain will leak past the donut....

I have a 2000 suburban and I notice on start up the smell of antifreeze, does anyone know what that could possibly indicate?

Following the sage advice found on this site in other postings, I managed to remove the misshapen, rusted waste pipe that went from my downstairs toilet to the horizontal main line (cast iron). So now I have a cleaned out bell and test fitted a neoprene donut from Lowe's (4" to 3") and plan on...

I am installing a PVC shower stall drain in a fiberglass shower unit. The drain unit has a rubber gasket and a friction gasket. Should I install the drain with or without a (latex adhesive) caulk applied to the gaskets? A picture of the drain unit is attached. (I hope)