Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Best way to cap a copper water line: compression fitting or copper cap?
[ 29 Answers ]
Hi all, Unsuccessfully tried to cap a copper water line by soldering a pre-soldered cap onto the end. Took all the proper steps, cleaned the ends of the pipe and fitting first, then applied flux around both. Wasn't quite sure what I should be heating, so I just heated everything. After my first...
How do I connect 3 inch sch 40 to 3 inch copper . The o. D. Of the copper is 3 inch
[ 2 Answers ]
I am remodeling an old house with all copper plumbing except for the cast iron that comes out of the basement floor. Some of the copper drain line is bad so I am trying to connect to the copper with sch 40 3 inch pipe. I can't seem to find a no hub band to make the connection. The o.d. of the...
Install Gas Shutoff Valve for stove.
[ 2 Answers ]
I have a 1/2 " gas line coming into my kitchen of my new house. I bought a 1/2" shutoff valve, 3 " Nipple, and 1/2" cap. In order to connect to a flex line I assume the nipple needs to come out of the shutoff valve (F/F Threads). Give me some guidance as how to install the line. I also bought some...
Install a copper shut off valve
[ 4 Answers ]
Is it necessary to take apart the 3/4 inch copper shut off valve prior to soldering it in place in order to avoid melting the ball seals?
How to install 72 inch long by 4 inch tall Marble Vanity Backsplash
[ 2 Answers ]
I just installed a new 72 inch long Marble vanity in my bathroom. It came with a 72 inch long by 4 inch tall Marble Backsplash. How do I install this backsplash? Do I just put an adhesive behind it? What about the gaps? How do I fill the gap of the top of the backsplash where it hits the... View more questions Search
|