Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Compression coupling
[ 2 Answers ]
What is the screw for inside the compression coupling? What happens if I remove it?
How to connect cpvc to compression shut off valve
[ 4 Answers ]
I am at my wits end I know this is supposed to be an easy fix but I have been trying to cement the compression shut off valve to a cpvc pipe and it pops completely off after 5 hours of drying time as if there was no cement at all. Any suggestions its nw 1:30 am here and my main water is still off.
Fernco neoprene coupling to connect two PVC pipes instead of a pvc repair coupling?
[ 3 Answers ]
Hi, A plumber was replacing some plumbing in our shower area. He connected two 2" PVC pipes that ran directly into each other with a Fernco Neoprene Coupling. In another place, he connected two 3" PVC pipes that ran directly into each other with a second Fernco Neoprene Coupling. In both cases...
Standard water Pipe compression coupling sizes
[ 4 Answers ]
I recently removed my shower mixer valve which was faulty, the intention was to replace it with a new unit. When I checked the compression coupling sizes they were 22mm, this does not seem to be a standard size which from visits to the hardware stores seems to be 15mm. Does any one know of any...
CPVC threaded coupling to Brass nipple is leaking
[ 5 Answers ]
I just installed a new sink in my garage using CPVC for the plumbing run. Never used CPVC before. Where I came through the wall, I used a CPVC female threaded fitting with ears on it to fasten to the wall stud. I then screwed a 4" brass nipple to it with teflon tape and attached the valve to the... View more questions Search
|