Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
New Supply Line
[ 11 Answers ]
I am running a supply line from my house to an outbuilding, where I will be supplying a bathroom (Complete with Shower), and a sink. I have done a trench 3 ft deep (Frost line in NC is 18 inches) to the building. I am planning on using 3/4 buryable pex. My question is where is the best place to...
Clog in water supply lines after replacing section at main municipal supply...
[ 1 Answers ]
I had an exposed water supply line that ran from the city inlet to my house. It was old and rusty so we decided to replace it with a PEX pvc piping. It's the same dia. (3/4") and we replace the one 90 elbow with a 45 instead. When we turned the water back on, it had no pressure, and after my...
How to increase pressure in supply line after addition of tee in line(05
[ 2 Answers ]
I added an outdoor frostfree water valve to the cold water supply line by teeing it in. The supply lines is .5 inch copper pipe as is the added line and fittings. The water source is a well. The water pressure seems to have dropped a lot even when using only one faucet at a time. The added line is...
Supply line won't stop running. Main water supply off
[ 3 Answers ]
I was doing some bathroom remodeling and attempted to remove an old supply valve. It would not budge so I decided to cut the copper tubing underneath it and put on a new shutoff valve with a compression fitting. The problem is that water just kept coming out of that supply line. The main water...
Changed out radiator w/copper supply baseboard w/ pex supply
[ 2 Answers ]
And there is no heat in eminating from this baseboard. This was done in one room only and off the original radiator line.the system is all hotwater radiator w/the exception of this one room. We did not change the original heating supply line to this but added valves and then the pex. Seems the hot... View more questions Search
|