Check out some similar questions!
Submersable Pump - 220 volt - Capacitor Overheating - Pump Shutting Off
[ 16 Answers ]
My 220 volt submersable well pump stopped working. We took the capacitor in to be checked one day and it was fine. The next day we took the relay in and it checked out. The following day I pressed on one of the wires that goes to capacitor and the well came on. The wire was old so I knew it...
Well pump not shutting off
[ 8 Answers ]
I had a problem with the water. When we would use it the water would shut off after 5 min. and then start back up after 5min.. So I replaced the perssure switch and now the well will not shut off when it reaches the correct pressure. What can I do to fix this?
Well pump not shutting off
[ 4 Answers ]
Ok, we installed a new bladder holding tank, preset points and pressure switch along with all new pipe. The plumber did not put a new pressure gauge on the line though. He said he would come back and put a new gauge on the line which he did not have with him at the time. After the installation...
Pisa Bristan Shower - water is always colder than the tap
[ 3 Answers ]
OK, I have a Pisa Bristan mixer shower. The shower, when turned to it's hottest setting, produces luke warm water, despite water from the tap being much hotter. I suspect that the mix of hot to cold water is not good even when I have turned the shower up to it's hottest. This is a permanent... View more questions Search
Add your answer here.
|