Ask Experts Questions for FREE Help !
Ask
    Kdogg27's Avatar
    Kdogg27 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 28, 2016, 08:08 PM
    Best way to remove PVC from mixing valve
    What is the best way to remove pvc from a shower mixing valve? I used it for the tub spout instead of galvanized steel. Should I use a heat gun in a tight location?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Nov 28, 2016, 08:31 PM
    Channel locks should work. PVC doesn't gall into the mixer like some galvanized pipe can. What's wrong with the PVC spout? I've seen people use sprinkler riser pipes.
    Kdogg27's Avatar
    Kdogg27 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Dec 2, 2016, 03:53 PM
    Tried channel locks but the plug is somewhat stripped. I had seen videos of people using a heat gun to melt it but didn't know if that was an option in a tight space
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #4

    Dec 2, 2016, 06:45 PM
    It probably won't hurt. Let's get this straight. I believe you used a PVC plug to fill the outlet of a mixing valve. Correct? If so, I would carefully drill a hole in it and use a pipe nipple extractor. You can find them at HD in the plumbing section and possibly in the Lawn Sprinkler section for removing pipe risers.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I can't seem to remove my TA-10 Symmons mixing valve [ 1 Answers ]

I removed the set nut from the TA-10 Symmons valve assembly, but the spigot valve won't unscrew more than half a turn. I don't want to snap anything or damage my pipe, but I put a lot of pressure on unscrewing it and it just won't budge more than half a turn.

Hot water problem - faulty check valve or mixing valve? [ 8 Answers ]

Hi, We have a weird problem with hot water running cold in our apartment. At all of the faucets and taps we only get hot water for a minute or two and have to turn off the faucet/tap for 30 seconds and back on again to get hot water. Then the same thing happens again. To get continuous hot...

Mixing valve problem [ 1 Answers ]

My shower mixing valve was fine when installed, but now I can't seem to get enough hot water.(rest of the house is fine) When I turn the valve all the way to hot it will get a little hotter but then I lose water pressure. It is a moen and there is only a shower unit. No tub. Thanks shulta44

Mixing Black (ABS) and White (PVC) pipes [ 3 Answers ]

I have to run new drain pipes for a toilet and sink installation. The sink has white (PVC) drain pipes and the toilet has black (ABS) pipes going into what I believe to be the sewer drain. Can I just connect the white to the black with a tee to drain the sink water? Do I need to vent the sink...

Mixing Valve [ 1 Answers ]

Okay I know nothing so where can I find the mixing valve on my shower to see if it needs cleaned out?

View more questions Search