Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Adding a laundry sink
[ 2 Answers ]
I'd like to add a laundry sink in our laundry room. The existing outlets are non-GFCI connected to a 20-amp circuit breaker. There's also the outlet for dryer if 220v connected to a double-pole 30-amp circuit breaker. Do all those outlets need to be converted to gfci?
Adding a laundry room and need 220
[ 2 Answers ]
How do I tap into a 220 volt line to run to another outlet? I have an unused 220 volt line going to the overn. I converted the oven to ags, and want to use that line to run to a laundry room I am building, but do not want to remove the line to the stove in case I sell later. Is there a way to...
Tying in to old 1/2" CPVC line
[ 3 Answers ]
If I want to ty in to a 1/2" CPVC pipe (warm water line) that is a few years old, how do I clean that connection?
Adding toilet in Laundry Room
[ 1 Answers ]
My father-in-law wants to add a toilet in his laundry room and since I have installed sinks and faucets for him, he thought I might be able to answer his question about accomplishing this new task... but I can not... He wants to know if he can add a toilet into the laundry room and he wants to...
Tying into waste line under slab
[ 5 Answers ]
Hello I'm tying a 3 inch horizonal ABS into an existing 3 inch horizonal ABS line at a 90 degree angle under a 4 inch slab.the main line will not move,is there a special y fitting to make the connection. Also have a venting question which would be easier with a picture how do I attach the jpg.Thanks View more questions Search
|