Ask Experts Questions for FREE Help !
Ask
    apardy's Avatar
    apardy Posts: 2, Reputation: 1
    New Member
     
    #1

    Apr 13, 2007, 09:34 AM
    Adapting Water Pressure?
    Hi! The water pressure to our home is too high, the pipes are rattling. I have read some of the other postings, and would like to know if installing a pressure gauge (as recommended) is an easy thing for an individual to do - or does one need a plumber?
    Thanks for insights!
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Apr 13, 2007, 11:34 AM
    You can add a pressure reducer but lets start with your current water pressure, normal is about 45 psi. The rattle could be water hammer but I'll wait to hear back from you before I go in the wrong direction.
    apardy's Avatar
    apardy Posts: 2, Reputation: 1
    New Member
     
    #3

    Apr 13, 2007, 01:48 PM
    Thanks for responding. It is definitely a water pressure issue. It is a new system, and the water company sent a pressure gauge. Is this something my husband can do?
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
     
    #4

    Apr 13, 2007, 04:12 PM
    A pressure gage won't fix the problem, only measure it. To lower the pressure, you need a pressure regulating valve, and to set it, you do need the pressure gage.

    Whether you husband can instal it depends on his skill and the type piping you have. Almost anybody can work with PVC. A little experience helps with copper. PEX isn't that DIY friendly either. They are sort of expensive, but there are ''Shark's Tooth'' fittings. They are quite easy to use with copper, PEX, and CPVC. Ace Hardware and plumbing supply house have them. I haven't see them elsewhere.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Surging water pressure & leaking water heater relief valve [ 19 Answers ]

Just recently the pressure of our water in the house surges when we turn a faucet on, and the city water company verified that our pressure in the house when we open a faucet is higher than the pressure in the lines in the street, and after the water runs is at a normal pressure (meaning their...

Water line replacement = entire house low water pressure [ 3 Answers ]

I recently had a water line break in my front yard. The city replaced the line but ever since (immediately following the water being turned back on) the water pressure has been significantly lower throughout the house in both the hot and cold. I checked and the valve is completely open so I am...

Low water pressure oil hot water heating system [ 1 Answers ]

How does one go about increasing water pressure in a baseboard heating system?

House water pressure from well losing pressure [ 2 Answers ]

I have a well at my home that provides the primary water . I have replaced the well pump with a new one, the pressure tank was bad replaced it, pressure switch was bad replaced it. Now I cannot maintain pressure through out my house. The initial pressure is good for about 10 seconds then it slowly...

Low water pressure in an area known for high pressure [ 3 Answers ]

Greetings, My wife and I are in the process of updating 1957 side by side split level. The previous owner (OK, my Mom as I bought the house I grew up in from her) said that when they moved in they had to install a pressure reducer into the line. I have searched high and low but, I can't see...


View more questions Search