 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have 3 electric baseboard heaters in an open concept living, room dining room and kitchen set-up each on its own circuit and wall thermostat. Is there a way of putting all three or at least two, on one thermostat? I have checked with an electrician and he said no.
How can an AC MCB be used in DC circuits. How is the breaking capacity decided in an MCB? Does an MCB work in over and under load applications?
The location is in a finish basement which will have a small enclosure 3'*3'*4’ high, hiding sump pumps and drain pipes to the outside. It is recommended to put the pumps on two different circuits; one will be on an existing 20amp circuit using 12/2 and is running 3 receptacles protected by a...
I am trying to add a few more 240V circuits for a welder and plasma cutter in the shop. The 200 amp panel is already full (4 30amp, A LOT of 20 amp, and a 100 amp service piggybacked). I have a new 200 amp service set at a barn about 50 ft. from the shop. Can I run another 100 amp service into...
Suppose that the switch has been closed for a length of time sufficiently long for the capacitor to become fully charged. (a) Find the steady-state current in each resistor. R1=16.00 kΩ, R2=12.00 kΩ, and R3=2.00 kΩ. (b) find the charge on the capacitor. 9.00V, 10.0uC I found part (a) but I'm...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
