Need info on the best way to tie in washer stand pipe. I tied it in to my 2"vtr which ties into the end of my 3"sewer drain underground. Above the stand pipe is the 2x1.5 sant. Tee for the lav. Vent a clean out at 9" of slab and then to roof, nothing else on the 2" vtr. I think its OK but not 100%...

I already ask a question and would like to thank Milo Dolezal,massplumber2008 for their answers. And would like to get their opinions on this setup. http://www.flickr.com/photos/36142943@N02/3338838502/in/photostream/ http://www.flickr.com/photos/36142943@N02/3340195109/in/photostream/ ...

Hello I'm doing a remodel of my laundry room, I would like to lose the utility sink and the washer line that drains into it. I would like to go with a sink that is mounted in a counter. I don't think I can put in a laundry stand pipe because the drain pipe is 1.5 inch. Do you need 2...

I've had to route my washer drain out of my septic system (drain fields are bad). In the house crawl space the washer pipe 2" pvc came through the floor one bend (elbow) and 3' of travel to the septic cast iron pipe down to the septic tank. I cut into the pvc just past the elbow (maybe 2' past)...

Tom, how you doing? Hope you had a great newyears. Now for my question. My main stand pipe that I will have to tie into is 4 in. cast. The present drainage comes off the cast at what looks like a 4 in. sanitary T. My present drain that ties into the cast is run out of 3 in. copper. Is it possible...