Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bending 1/2 " cooper pipe
[ 2 Answers ]
I'm a novice do-it -yourselfer. I'm trying to replace a new shower but the new valve I purchased does not line up with the old cooper piping supply lines. It is 1/2" cooper and is off about 3/4" on either side of the fixture. Can Cooper piping be bent slighting and if so how? Thank you.
Side of TV picture bending inward
[ 2 Answers ]
I have a Sony Trinitron TV that is 13 years old, I have never had a problem with it but about 2 days ago there is a black frame on the sides that is bending inward . I can still watch TV but since the sides are bent inward it elongates the people, picture and it is very annoying. Any ideas what...
Schedule A Deductions and Schedule C - No AGI
[ 1 Answers ]
Hi, I am a sole proprietor (an electrician) and after finishing schedule c I basically had very little profit to report from the business. With no other Adj Gross Inc, I started to figure my itemized deductions, but with no Adj Gross Inc, how can I best use my itemized deductions? Thanks,
How to clean out galvanised pipe
[ 4 Answers ]
So the line to the house has lots of pressure, tested it outside. But here is where it gets tricky. MOst of the pipe is galvanized, that goes to copper. There is very little pressure throughout the house, and its well pretty pathetic. So since the pressure is great outside, we figure the... View more questions Search
|