I want to cut a 45degree angle on a 8inch steel pipe so that I can put the to 45 degree angles together and weld them. How can this angle be laid out on paper for pattern.Thank you Builderbob27b.
Add your answer here.
Check out some similar questions!
Cutting pipe at an angle [ 7 Answers ]
I need to occasionally cut round pipe at an angle but always have trouble. Is there any way of doing this by marking out line with a pattern or similar device? The only cutting devise I have is 9" angle grinder. The pipe can be up to 4"diameter and wall tgickness from 1/16th to 1/4 inch. Any help...
Velocity at 30 degree angle [ 3 Answers ]
I want to check if I am on the right track. Question: Santa loses his footing and slides down a frictionless snowy roof that is tilted at 30 degrees. If Santa slides 10m before reaching the edge, what is his speed as he leaves the roof? Would I use ax=g sin (theta) and then take my results...
One inch gas pipe [ 3 Answers ]
What length of unthreaded one inch gas pipe should be exposed when stubbed out from a finished wall
Cutting a pipe on an angle [ 4 Answers ]
How do I cut a pipe on a angle?
Installing ceiling fan on 70 degree angle [ 3 Answers ]
Help I am trying to install a ceiling fan on a sloped ceiling, 70 egree angle. I am just replacing the one the builder put in, but I can't find one that will fit that steep of a sloap. The one I am trying to install is a harbor breeze model from Lowe's. Then I went to Home Depot and asked what...
View more questions Search