Is Acylonitrile Butadine Styrene toxic when cut with a laser

jaurell Posts: 1, Reputation: 1

New Member

Sep 14, 2010, 11:23 AM

Is Acylonitrile Butadine Styrene toxic when cut with a laser

I'm cutting sheets of Acylonitrile Butadine Styrene with a laser and need to know if the smoke that I'm vacuuming from the sheet needs to be filtered?

Check out some similar questions!

My blower on inside unit will not cut off I cut and crimped wires back together [ 1 Answers ]

Where do I put the blue and red wire to the blower on the inside unit

What is the best way to bond Unplasticed PVC to ABS (Acrilo-Butile Styrene)? [ 1 Answers ]

We are currently having problems with our current bonding method. We bond the Unplasticed PVC to ABS and then cut a chanel out of our PVC, effectively turning it into two separate pieces both bonded to the ABS. However the bond isn't strong enough and when we cut the PVC it is moving and...

Styrene base over old tile floor? [ 2 Answers ]

I have an old tile shower that was leaking and was going to put a new enclosed styrene unit in instead. I'm kind of scared to start jackhammering to remove the old mortar base - won't I crack the drainpipe? Would it be OK (or wiser) to leave the old floor in place, build a platform above it,...

Can I glue styrene fitting to PVC? [ 1 Answers ]

Hello! I just recently purchased a quantity of 4" PVC sewer & drain pipe to drain the water from my downspouts to a small drainage lake in my backyard. I asked the supply house for PVC pipe and fittings, but when I got home, I discovered that the fittings are stamped as 'styrene', while the pipe...

View more questions Search

Check out some similar questions!

Add your answer here.