Ask Experts Questions for FREE Help !
Ask
    hashah's Avatar
    hashah Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 21, 2007, 06:55 AM
    AC Motor
    Can I Run 5 HP 1440 RPM AC Induction Motor at 0.5Hz. By VFD if I get desired torque and if my current is within limit?
    ikrajput's Avatar
    ikrajput Posts: 3, Reputation: 1
    New Member
    		  
    #2

    Sep 25, 2007, 05:50 AM
    What is shunt trip
    ikrajput's Avatar
    ikrajput Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Sep 25, 2007, 05:52 AM
    What is CLD in electronic
    caibuadday's Avatar
    caibuadday Posts: 460, Reputation: 10
    Full Member
    		  
    #4

    Sep 26, 2007, 07:10 PM
    Quote Originally Posted by hashah
    Can I Run 5 HP 1440 RPM AC Induction Motor at 0.5Hz. By VFD if i get desired torque and if my current is within limit?
    the spec on mine say it should not run less than 20%(12hz),it would hurt the motor: something about harmonic distortion... If your is at 0.5 , it is less than 1 rev per second, would that make yours worst??
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ok now the motor went out again! [ 1 Answers ]

OK I put the capasitor in. and now it starts on its own. Were is before I had to give it a push but, it runs for a couple hours and goes out. I ran down this last time and the motor was cool as a cucumber. Now what? Thanks... is a 15 year old carrier.

Motor control [ 3 Answers ]

What is diff between Vacuum contactor (with fuse) and Vacuum Circuit Breaker? Which one is better for motor control? Is there is any criteria for selection?

Connection of dc motor [ 1 Answers ]

Do I have to use thick wire all the way to 12 volts battery to connect dc motor for lifting purposes? And what materials do I need to complete this project? Motor is 0.8 kw rating with solenoid sitting piggy back, a diagram would be much appreciated, great site this .:)

GE motor [ 1 Answers ]

I have a GE motor that I believe is from an old washer. It has 5 wires. Black to white is 0 ohms, red to white or red to black is 3.9 ohms, yellow to blue is 2.0 ohms. There appears to be "no" centrifugal switch, so I don't think it's a capacitor start but with all the wires I think it might be a...

AC Motor [ 1 Answers ]

How Do You Rewire a AC Motor that is used on Conveyors?

View more questions Search