Ask Experts Questions for FREE Help !
Ask
    eyanez's Avatar
    eyanez Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 28, 2012, 07:10 PM
    What do I need to connect to teltab 8110 modem?
    I have a teltab 8110 moden with 2 coax cables, ISP say it is ready, how do I connect switch? I do not see this type of connector on switch
    EmranKhan's Avatar
    EmranKhan Posts: 8, Reputation: 2
    New Member
    		  
    #2

    Jul 11, 2012, 02:55 AM
    As far as I think you can not connect a NTU to a Switch directly.
    You have to connect the NTU to the Router and the Router to the Switch.
    That's how my company configured or installed in banks and hospitals n other places.

    There is the DCE and a DTE RS-232 cable.
    You have to check the interface of the router and the NTU modem and then depending of the interfaces get the appropriate cable.
    My company used a cisco Router and we mostly used RS-232 DTE Smart Serial cable because the router had a WIC-2T Smart Serial Interface.

    The Cable goes from Router's Serial Port to the NTU's interface.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Telabs 8110 modem ican I used it as leased line modem [ 3 Answers ]

In my office there is a Tellabs 8110 modem from where internet is connected . Is it is a leased line modem or it is a fixed ip broadband modem :)

Tellabs modem 8110 [ 2 Answers ]

Hi, I just want to ask u guys about tellabs 8110 modem on how to configure it out.. Thank you

Tellabs 8110 modem [ 1 Answers ]

Sir, I have the leasedline communication of 64kbps with tellabs 8110 modem on both ends, I want to connect the PC comport in both ends. Through which media it is possible? By routers is it possible? Is there any synchronization in tellabs modem? If synchronization is there then how I can...

View more questions Search